產品中心
PRODUCT
殺菌劑SJ-2
一、產品簡介:
本產品為新型改性聚胍類高效廣譜殺菌劑,在水溶液中能產生電離,它的親水基部分含有強烈的正電性,吸附通常呈負電性的各類細菌、病毒,進入細胞膜,抑制膜內脂質體合成,造成菌體凋亡,達到最佳的殺菌效果。本品具有低毒、可降解、抑菌濃度低、不產生耐藥性等特點?蓮V泛應用于日用化學工業、水處理、醫療衛生、油田酸化壓裂和聯合站等領域,對于硫酸鹽還原菌、腐生菌、鐵細菌均有強的殺滅效果,同時對霉菌、藻類等有很強的殺滅及抑制效果。
二、技術指標:
表1殺菌劑SJ-2技術指標
項 目 |
技術指標 |
外 觀 |
無色至淡黃色透明液體 |
pH值 |
6-9 |
有效含量,% |
40 |
三、 使用方法:
1. 建議使用量:30-50mg/L。本產品為高含量原液,用于酸化壓裂推薦稀釋比例為1:2-1:3,用于聯合站推薦稀釋比例為1:2-1:1;
2. 其他領域使用可根據實際情況進行一定比例的水稀釋。
3. 按比例加入工作液中,循環均勻即可。
四、包裝貯運:
1. 包裝:采用200kg塑料桶包裝,也可按用戶要求包裝。
2. 貯存:貯存于陰涼處、通風處,有效期1年。
五、操作注意事項
一、 操作人員應穿戴乳膠手套及防護眼鏡等防護品。操作過程注意通風。
二、 如遇本物觸及皮膚時可用大量水沖洗后再用肥皂洗凈即可;如遇本物品濺入眼睛請在現場立即用水充分清洗之后立即就醫檢查。
三、 如遇火災,可用干粉、泡沫、CO2 等滅火器以及黃砂滅火。
Fungicide SJ – 2
I. Product introduction
This product is a new type of modified polyguanides with high efficiency and wide spectrum fungicide, which can produce ionization in aqueous solution. Its hydrophilic part contains strong positive electricity, which can absorb all kinds of bacteria and viruses with negative electricity, enter the cell membrane, inhibit the synthesis of liposomes in the membrane, cause the apoptosis of bacteria, and achieve the best bactericidal effect.This product has the characteristics of low toxicity, degradable, low concentration of bacteriostasis and no drug resistance.It can be widely used in the fields of daily chemical industry, water treatment, crude oil pipeline transportation, oil field acidification fracturing and joint station, etc. It has strong killing effect on sulfate reducing bacteria, saprophytic bacteria and iron bacteria, and strong killing and inhibiting effect on mold and algae.
Ii. Technical indicators
Item |
Technical indicators |
Outside view |
Colorless to pale yellow transparent liquid |
pH |
6-9 |
Effective content,% |
40 |
Iii. Method of use
1. Recommended dosage: 30-50mg/L.This product is a high-content original solution, and the recommended dilution ratio for acidizing fracturing is 1:2-1:3, and the recommended dilution ratio for combined stations is 1:2-1:1.
2. In other fields, a certain proportion of water can be diluted according to the actual situation.
3. Add it to the working fluid in proportion and circulate evenly.
Ⅳ. Packaging, storage and transportation
1. Packaging: it is packaged in 200kg plastic barrels, or according to the requirements of users.
2. Storage: stored in a cool and ventilated place, valid for 1 year.
V. matters needing attention in operation
1. Operators should wear latex gloves, protective glasses and other protective products.Pay attention to ventilation during operation.
2. If the product touches the skin, rinse with plenty of water before washing with soap.In case of eye splash, please wash the product with water immediately and seek medical advice immediately.
3.In case of fire, dry powder, foam, CO2 and yellow sand fire extinguishers can be used.